Zanussi ZNFN18FS1 Manual De Instrucciones página 15

Problem
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Some specific surfaces inside
the fridge compartment are
warmer at some times.
Temperature setting LEDs flash
at the same time.
Possible cause
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastFreeze function" is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
An error has occurred in meas-
uring the temperature.
Solution
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func-
tion" manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "FastFreeze function"
section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
This is a normal state.
Contact the nearest Author-
ised Service Centre. The cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible.
15