Auta 721154 Manual De Instrucciones página 6

Specifications
Fingerprint capacity:
Cards_Key fobs capacity:
Proximity technology:
Production:
Push-button input:
Opening time:
Input mode:
Programming:
Admin_Installer fingerprint:
Backlight ON_OFF:
Buzzer ON_OFF:
Firmware update:
Consumption:
Supply:
Indication:
IP factor:
Store_Functioning temperature:
Store_Functioning humidity:
Dimensions (mm):
Mounting
1.
5mm
Recommended swipe technique
Follow the below instructions for correct finger swiping. Starting from the first finger joint, place the selected
finger on the swipe sensor and move it evenly towards oneself in one steady movement.
Result:
For a valid swipe: Tricolour Status LED turns green + OK Beep(short + long beep)
For an invalid or misread swipe: Tricolour Status LED turns red + Error Beep ( 3 short beeps)
x 6
The fingerprints are enrolled in the system by swiping the finger a minimum of 6 times.
Indication
97
2000
Compatible with EM or HID (125KHz)
1 relay (2A_24V ac_dc)
Yes
Press (from 1 to 30 seconds) or Toggle (ON_OFF)
Fingerprint or card
Swiping
1 Admin y 1 Installer
Yes
Yes
Trough RS485 and Windows application
150 mA
9-14 Vdc
Tricolour status LED
IP65
from -20 °C to +50 °C
HR of 5% to 93% without condensation
100 x 94 x 30
2.
4 (4 x 30mm)
Green - Access granted
Red - Access denied
Orange
- Idle mode
3.
OK beep - short + long beep
ERROR beep - 3 short beeps
Swipe finger - 2 short beeps
EN
100 mm
94 mm
30 mm
4.