Transport, Packaging And Storage; Inspection After Transport; Packaging; Storage - Casselin CTQPM Manual De Instrucciones

3. TRANSPORT, PACKAGING AND STORAGE

3.1 Inspection after transport

The check for the absence of damage and the completeness of the device must be made upon receipt of the
package. In the event of identification of damage due to transport, refuse or accept the delivered product only
with reservations *. A complaint detailing the defects observed must then be made. The perception of damage
is only possible in the event of a complaint formulated within the prescribed time limits, ie 24-48 hours
maximum.
* written on the carrier's delivery papers or digital.

3.2 packaging

The packaging of the device must be kept in case of moving, or for a return to the after-sales service. The
inner and outer packaging must be completely removed before using the device. The standards in force in
your country concerning environmental protection must be observed before destroying the packaging.

3.3. Storage

WARNING
The device can be kept in stock, but only in its original, closed packaging.
Storage can be carried out in accordance with these conditions:
• Storage in a dry and non-humid place
• Sheltered from the sun
• Control of the stock exceeding 2 months (general condition of the device and all the constituent elements)
• No material shaking
• Storage in closed room and not outside.

4. EQUIPMENT CHARACTERISTICS

* Subject to change
Model
Electrical data
Dimensions
Weight

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
CTQPM
2200 W / 230 V
W 575 x D 360 x H 300 mm
12.35 Kg
CTQGM
2,800 W / 230 V
W 680 x D 500 x H 600 mm
20 kg
EN