Casselin CSC2 Manual De Instrucciones página 17

EN
- Insert the dowels into the holes.
- Screw the plastic part which clips to the hair dryer support in the wall using one of the screws provided in
the top hole.
- Then take the screws and screw them into the wall through the holes in the hand dryer support. Secure
the hair dryer support then cover the holes with the plastic covers available.
- Plug in the appliance, set the main switch to ON, take the handle while keeping the switch pressed to
activate the hair dryer, release it to stop drying. You can adjust the air power using the switch on the
outside of the handle. Place the hair dryer back on its support and turn the switch to OFF.
- Test it several times to verify the correct functioning of the device.
- The installation of the hair dryer without a wall outlet must be carried out by a qualified
professional who bears full responsibility.
- The installation of the hair dryer in a drawer is prohibited
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.