Use - Casselin CCAEF Manual De Instrucciones

WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the
device in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
INSTALLATION
Take the egg cooker out of the packaging and place the appliance on a flat, smooth surface. Detach it
plastic coating of the device.
If this appliance is placed near a wall, partition, kitchen cabinet, decoration, etc.,
they must be covered with a suitable non-flammable coating or thermal insulation material
fuel and that the power supply is in accordance with fire prevention regulations.
Once the egg cooker has been set up by consulting international standards and regulations.
The egg cooker is ready for use.
SURGERY
Fill the water tank to the level indicated. Use clean water each time you use it.
Plug in the device and turn it on, turn the temperature knob clockwise
to the desired setting, the element begins to heat up and the green light is on. A parameter of
operation is in position 5 (approximately 65 to 80 degrees). When not in use, you just need
simply turn off the temperature button, turn off and unplug the unit.
SECURITY
Do not fill the water tray with too much water, the appliance has been installed with a thermal cutout to
avoid
overheating or damage to the elements.
If the power cord is damaged, it must be replaced by a qualified technician.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
EN