MANUAL
EN
Unpack all supplies and remove any packing material
Check supplies
Fix the hand basin near a water inlet
Check that the wall can support the weight of hand-washing, checking the properties of the wall.
Fix the swivel tap in washbasin
Drill two holes in the wall with good spacing (check clearance with a measuring device on the washstand)
Mount the dowels into the holes and hang the washing hands using the supplied screws
Connect the washbasin with the mounting hardware supplied with the unit
Connect the drainage pipe
Operate washing hands with your knee to check its operation, the water has to flow for about 15 seconds
Adjust the pre mixer using the control knob
6. MAINTENANCE
Clean regularly wash hands with a non-corrosive cloth and cleaning product.
NOTE
Waste used devices: any old appliance must, upon disposal, observe the regulations of the country *. It is
imperative to make it unusable before disposal by removing the power cable.
* In ecology and recycling.