Home Decorators Collection 273-628 Manual De Instruciones página 6

INSTALLATION & ASSEMBLY (cont.):
5. Place the Wall Plate (#10) over the Outlet Box (#4) and onto the Fixture
Mounting Screws (#6), and adjust the Fixture Mounting Screws (#6) until
they protrude out from the Wall Plate (#10) 1/4". Remove the Wall Plate
(#10) and secure the position of the Fixture Mounting Screws (#6) by
tightening the Hex Nuts (#9) against the Mounting Bracket (#7). Place the
Wall Plate (#10) back onto the Fixture Mounting Screws (#6), and secure it
into place using the Lock Nuts (#3) provided (Fig. 1).
6. After installing the fixture, caulk the upper 2/3s of the Wall Plate (#10) to
mounting surface. Leave the bottom 1/3 un-caulked for drainage of any
water that might leak drainage of
any water that might leak into the
enclosure.
recommends a non-drying exterior
caulking material.
example is a clear silicone rubber
sealant for exterior use.
7. Slide the Shade over the Socket,
onto the Socket Cup. Secure the
Shade to the Socket Cup using the
Socket Ring (Fig. 2).
8. Install up to a 100 watt Light Bulb
or Listed SBCFL (Self-Ballasted
Compact Fluorescent Lamp [not
provided]) in the socket of the
Main Fixture Body. Do not exceed
a 100 watt incandescent light
bulb, or a 26 watt SBCFL (Fig. 2).
9. Installation is complete. Turn on
power at the circuit breaker or
fuse box. Turn the light switch on
to activate the fixture.
The manufacturer
A good
Fig. 2
Page 6