Tol - Kroeplin C0 Serie Manual De Instrucciones

Program: TOL
The measuring unit („mm" and „inch") and scale interval have to be
selected before setting the tolerance limits otherwise incorrect
measuring results may occur.
Configuration tolerance ranges: Example tolerance range 3 / Adjusting the tolerance limit –
Example: 10,00 ±0,1mm in the „Absolute – Mode"
Activating the SETUP – Menu in the
„Absolute – Mode"
1x long
„tOL" will appear in the display
2x short
"1" for tolerance range 1 will appear in the display
1x long
The last selected status will appear in the display / Factory setting: 1
Switch to tolerance range "3"
2x short
„tOL LO" will appear in the display for 2s
1x long
The last saved lower tolerance value will appear.
38
Adjusting lower tolerance limit (9,90mm)