Celestron POWERSEEKER 50AZ Guía De Instalación Rápida página 2

10
Properly assembled the optical tube should appear as pictured above.
13
Replace the knurled nuts to secure in place and remove the lens
covers.
16
Place the 20mm eyepiece into the barrel of the diagonal as shown
above. Tighten the set screw to secure in place.
19
For additional magnifi cation, you can use the included 3x Barlow lens.
Place the Barlow lens in the focuser in place of the eyepiece. Remove
the cap from the Barlow lens.
2 | E NG LISH
11
HOLD
Remove the knurled fi nderscope nuts from the optical tube.
14 14
Loosen the set screws on the focuser and remove the plastic cap.
17
Remove the lens cap from the front of the telescope.
20
Insert the barrel of the 20mm eyepiece into the Barlow lens and
tighten the screws to secure it in place.
12
Orient the fi nderscope so that it is facing towards the front of the
tube. Place the fi nderscope over the screws as shown.
15
Insert the diagonal into the focuser and tighten the set screws to
secure in place. Remove the plastic cap on the diagonal.
18
To observe, look through the eyepiece as shown above. Focus the
image by turning the knobs below the focuser.
For more information on this product or to download
the instruction manual, please visit the respective
product page on celestron.com
SOLAR WARNING: Never attempt to view the sun
through any telescope without a proper solar fi lter.
NEED ASSISTANCE?
Contact Celestron Technical Support
celestron.com/pages/technical-support
09-19