Desktop Installation; Rackmount Installation - Intellinet Network Solutions 561402 Instrucciones

8-Port Gigabit Ethernet PoE+ Switch with 2 RJ45 Gigabit Uplink Ports
DIP Switch (Manual restart of switch is required for mode change to take effect.)
• Standard: default mode; allows normal communication between ports 1 – 10.
• VLAN: isolates ports 1 – 8 from each other but can connect to ports 9 or 10;
increases the forwarding rate when broadcast storms occur.
• Extend: allows PoE to be sent over distances up to 250 m (820 ft.); lowers data
transmission speeds to 10 Mbps.
Rear Panel
Power
Use the included power cord to connect the device (on the rear panel) to an AC outlet.
The device supports AC 100 – 240 V, 50/60 Hz.
Chassis Ground Column
Located on the right side of the power supply connector, a grounding terminal
connector is used to provide proper grounding for your Intellinet Network Solutions
data switch. If you use the chassis grounding screw, it should be wired to an object that
provides earth ground. In rackmount installations, grounding is typically provided by
the metal frame of the mounting rack.
Placement

Desktop Installation

Prior to use, it is recommended that the switch be placed/positioned on a level surface
with at least 25 mm (approx. 1") of clearance for ventilation; away from sources of
electrical noise: radios, transmitters, broadband amplifiers within 100 m (approx. 328')
of network devices it's to be connected to. Attach the rubber feet to the bottom of each
corner of the switch to increase stability.

Rackmount Installation

The switch can be mounted in an EIA standard-sized, 19-inch rack. Attach the mounting
brackets on the switch's side panels (one on each side) and secure them with the screws
provided.
Use the screws provided with the equipment rack to mount the Intellinet Network
Solutions data switch on the rack.
English
3