Publicidad
Idiomas disponibles
Idiomas disponibles
3.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
Use the original packaging to transport and store the device.
Keep this manual for future reference.
4.
Overview
Refer to the illustrations on page 2 of this manual.
1
grille mounting screw
2
front grille
3
fan blade mounting screw
4
fan blade
5
fan blade mounting nut
6
rear grille
7
grille mounting nut
5.
Assembly
Assemble the fan as follows:
1.
Loosen the grille mounting nut from the motor housing.
2.
Position the rear grille firmly to the motor housing. Fasten it with the mounting nut.
3.
Push the fan blade along the motor shaft.
4.
Hang the front grille on the rear grille using the grille clamp. Fix the grilles together with the clips on
the rim of the front grille. Fix with the screw and nut.
5.
Mount the feet onto the base. Fix the base onto the stand.
Your fan is now ready for use.
6.
Operation
To use the fan:
1.
Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can be sucked into
the rear of the fan.
2.
Insert the power plug into the mains.
3.
Set the desired output speed using the speed buttons: 0 = stop; 1 = low; 2 = medium; 3 = high.
4.
Push down the oscillation knob to make the fan oscillate. Pull up the oscillation knob to fix the fan's
direction.
5.
Always switch off and unplug from the mains before moving the fan.
6.
Switch off and unplug from the mains after use.
7.
Cleaning and Maintenance
Disconnect the device from the mains prior to maintenance activities.
Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap.
Remove soap remnants with the damp cloth. Do not use abrasives.
Make sure no water or any other liquid enters the motor assembly or the control buttons.
Keep the ventilation holes of the motor assembly free from dust at all times.
V. 03 – 10/10/2017
CFAN030P/CFAN040P
8
9
10
11
12
13
14
4
motor housing
oscillation knob
stand
base
base screw
feet
speed buttons
©Velleman nv
Publicidad
