Input Source; Using The Function; Channel Menu - npg NLD227B-P Manual De Usuario

You can select the input source by pressing the SOURCE button on the remote control.
Press【 】/【 】button or Source button to cycle through the input source.
Or you can select input source by pressing TV/AV button on television.〖CH+〗/〖CH-〗
button is used to cycle through different input sources. You can press TV/AV button to
confirm after choose some input source. If you do not confirm the input source within 1
minute,TV will automatically enter into certain source. For example:
NOTE: The picture is just for reference. Please operate with the OSD MENU of
concrete TV and refer to the AV terminal board.
Menu overview
Many function settings and adjustments of the LED TV will begin from the menu
choosing. All operation can be followed as help bar shows. Press【MENU】button to
display the main menu; Press MENU button or【 】/【 】button to cycle through the
main menu: Channel, Picture, Sound, Timer, Option ,Lock. Press【 】/【 】button to
highilght the item to be adjusted.
Press 【 】 / 【 】 button to adjust the submenu or subitem. When you satisfied with your
adjustment, press【EXIT】button to exit the main menu.
When an item in MENU is displayed gray, it means that the item is not available or
cannot be adjusted.
Press MENU button on the TV set or on the remote control to select the Channel menu.
Shown as below:
•Channel
To display the current channel number and press
【 】/【 】button to adjust it.
•Sound System
Four modes to be selected : D/K, I , B /G, L (In TV
mode) .

Input Source

Using the Function

Channel Menu (In TV, DTV mode)
Input Source
DTV
TV
SCART
Component
- -
PC RGB PC RGB
HDMI1
HDMI2
AV
S t o r a g e
EXIT
EXIT ENTER OK
11