Installing / Removing Battery Pack - Black+Decker LSW20 Manual De Instrucciones

wARnInG:
to get inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.

InstALLInG / REmOvInG BAttERy pACk

tO InstALL BAttERy pACk:
Insert battery pack into tool until an
audible click is heard (figure B).
Make sure battery pack is fully seated
and fully latched into position.
tO REmOvE BAttERy pACk:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool assembly
nOtE: Ensure the sweeper is
switched off and the battery is
removed before attaching or removing the sweeper tubes. The
inner tube must be assembled to the housing before use.
• tuBE AssEmBLy: To attach the inner tube to the sweeper, line
up the tube with the sweeper housing as shown in figure C.
Push the tube into the sweeper housing until the lock button
engages the lock hole in the tube. Repeat this process for the
outer tube.
C
shock hazard. Do not allow any liquid
B
CAutIOn:
safety glasses. Wear a filter mask if the
operation is dusty. Use of gloves, long
pants and substantial footwear is
recommended. Keep long hair and loose
clothing away from openings and moving
parts. THIS SWEEPER IS FOR
HOUSEHOLD USE ONLY.
• Hold the sweeper with one hand as
shown in figure D and sweep from side
to side with the nozzle several inches
above the ground. Slowly advance
keeping the accumulated pile of debris
in front of you.
SWITCHING ON AND Off (fIGURE E)
wARnInG:
HANDS TO GRIP THE PRODUCT fIRMLY
WHEN SWITCHING ON.
To switch the sweeper on, slide the on/off
switch forward .
To switch the sweeper off, slide the on/off
switch back.
CAutIOn:
UNIT DISCHARGE AT SELF OR BYSTANDERS.
7
OpERAtIOn
D
Always wear
USE BOTH
E
DO NOT POINT