ESX QUANTUM Serie Manual De Instrucciones página 7

INTERCONNECTION
ATTENTION: Before you start with the installation, disconnect the ground connection from the ve-
hicle's battery in order to prevent short circuits. Use the enclosed cable plug to connect each terminal.
First connect the GND terminal of the amplifier to an appropriate ground connection at the chassis. To ensure a
good connection, residue dirt and dust from the connection point. A loose connection may cause malfunctions
or interferences noise and distortion.
Then connect the +12 V terminal of the amplifier with the battery by using an appropriate cable including an
in-line fuse. This fuse should be located very close to the battery; for safety reasons not more than 30 cm
away. Only insert the fuse when the installation, including the connection of the loudspeakers, has been ac-
complished.
CAUTION: Never use the high level inputs and the RCA inputs at the same time. This may damage the
device seriously. Use the enclosed cable plug to connect each terminal.
INTERCONNECTION BY RCA INPUTS WITH TURN-ON SIGNAL (REM):
INTERCONNECTION BY HIGH LEVEL INPUTS WITH AUTO TURN-ON:
External
fuse
20 A
Red (+12V)
Black (-12V Ground) connect to a suitable ground point
Blue (REM) connect with the turn-on signal wire of the car stereo
Not required in this connection variant
Cable remote control
External
fuse
20 A
Red (+12V)
Black (-12V Ground) connect to a suitable ground point
Blue (REM) not required in this connection variant
R – grey/black
R + grey
L – white/black
L + white
Not required in this connection variant
Cable remote control
12 V
Battery
L-CH
Connect to the RCA outputs of the
car radio
R-CH
12 V
Battery
Connect to loudspeaker outputs of the
car stereo
7