General Safety Rules - Delta 50-875 II Manual De Instrucciones

WARNINg FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.
• FOR YOUR OWN SAFETY, REAd ANd UNdERSTANd THE INSTRUCTION MANUAL BEFORE OPERATINg THE
UNIT. Learn the unit's application and limitations as well as the specific hazards peculiar to it.
• kEEP WORk AREA CLEAN. Cluttered areas and benches invite accidents.
• dON'T USE IN dANgEROUS ENvIRONMENT. Don't use this unit in damp or wet locations, or expose it to rain.
Keep work area well-lighted.
• kEEP CHILdREN ANd vISITORS AWAY. All children and visitors should be kept a safe distance from work area.
• dISCONNECT UNIT before servicing.
• CHECk dAMAgEd PARTS. Before further use of the unit, properly repair or replace any part that is damaged.
dO NOT USE THIS UNIT TO FILTER
METAL dUST. Combining wood and
metal dust can create an explosion or fire hazard. This
unit is intended to filter non-explosive atmospheres
only.
dO NOT USE THIS UNIT TO
dISSIPATE FUMES OR SMOkE.
Explosions or fire can result. This air cleaner is
intended for use where only dry airborne dust is
present. Its use should be limited to non-explosive,
non-metallic atmospheres.
dO NOT operate this UNIT until it is completely
1.
assembled and installed according to the
instructions. A unit incorrectly assembled can cause
injury.
2. OBTAIN AdvICE from your supervisor, instructor, or
another qualified person if you are not thoroughly
familiar with the operation of this unit. Knowledge is
safety.
3. FOLLOW ALL WIRINg COdES and recommended
electrical connections to prevent electrical shock or
electrocution.
4. dO NOT LIFT THIS UNIT BY THE POWER CORd.
Do not use the power cord as a hanging device. A
damaged power cord can cause electrical shock or
electrocution.
SECURELY ANCHOR THIS UNIT to a permanent or
5.
fixed supporting structure when suspending it from
the ceiling. A falling unit can cause serious injury.
Always keep a minimum of 7 feet between the bottom
of the unit and the floor surface to allow for sufficient
head clearance. Use only a chain rated for a minimum
of 150 lb. working load to adequately hold the unit.
Use steel S-Hooks that are at least 1/4" in diameter to

gENERAL SAFETY RULES

FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.
SAvE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
suspend the unit from the ceiling. Lag-type bolts used
to suspend the unit from the ceiling must be threaded
at least 1-1/2" into supporting structural members.
SUPPORT THIS UNIT or securely clamp it to the work
6.
surface when it is used in a portable application to
eliminate potential injury and/or damage to the unit.
7. ENSURE THAT THE INTAkE ANd EXHAUST AREAS
ARE CLEAR prior to starting the unit. Clogged intakes
or exhausts can cause an explosion and/or fire.
8. kEEP ARMS, HANdS, and fingers AWAY FROM THE
FAN. Avoid all exposure to rotating parts to prevent
injury.
9. dO NOT OPERATE THIS UNIT WITHOUT THE FILTERS
IN PLACE. Dust and other small debris will go directly
to the motor, causing over-heating and the potential for
fire and/or explosion.
10. dO NOT ATTEMPT to remove or replace the filter(s)
while the unit is running. Exposed fan blades can
cause severe cuts. Make certain that the unit is
disconnected from the power source.
11. MAINTAIN THE UNIT in top condition. Clogged filters
can increase the potential for fire or explosion. Follow
all instructions for changing and cleaning filters.
12. STORE THE UNIT in a location that eliminates the
potential for damage to the power cord. A damaged
power cord can cause shock or electrocution. Safely
store power cord on the unit to eliminate tripping
hazards.
13. TURN THE UNIT "OFF" and disconnect the unit
from the power source before installing or removing
accessories, before adjusting or changing set-ups, or
when making repairs. An accidental start-up can cause
serious injury.
3