Ryobi PAD02 Manual Del Operador página 7

NOTE: The battery pack should be recharged after
approximately five hours of use to reduce the possibility
of damage. Repeated deep discharge of the battery may
decrease storage capacity and battery life.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
CONTROL BUTTONS
See Figure 2, page 9.
Use the control buttons to turn the speaker on and off, play
and pause audio, disconnect BLUETOOTH
control the volume.
TURNING THE SPEAKER ON AND OFF:
Press the on/off button to turn the speaker on and off.
When the speaker is on, a battery pack is installed, and a
BLUETOOTH enabled device is paired the LED light will
®
turn solid. If the battery charge is low, the LED will pulse.
NOTE: When the battery charge is low, the speaker will say
"Battery Low".
PLAYING AND PAUSING AUDIO:
When streaming audio from a BLUETOOTH
press the PLAY/PAUSE button to pause the track and press
it again to resume.
DISCONNECTING BLUETOOTH
Press and hold the PLAY/PAUSE button for three seconds
to disconnect a paired BLUETOOTH
ADJUSTING THE VOLUME:
When the speaker is turned on, the unit will return to the last
volume setting used.
 To increase the volume, press the VOL + button.
 To decrease the volume, press the VOL – button.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 8 AFTER FRENCH AND
OPERATION
devices, and
®
enabled device,
®
DEVICES:
®
device.
®
SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS START ON PAGE 9.
7 - English
NOTE: Volume for any connected device can be adjusted
using the volume control for that device and/or with the
VOL + or VOL – buttons on the product.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE SPEAKER
See Figure 3, page 9.
 Install a battery pack and turn the speaker on.
NOTE: The speaker will say "Power On" and automatically
attempt to connect to the last device it was paired to. If
no device has been previously paired, the LED will flash.
 Set your device to search/scan for available BLUETOOTH
signals, then select "RYOBI PAD02" from the list. No
password or PIN is required for connection.
NOTE: For best results, BLUETOOTH
should be within 50 ft. of the speaker and set to search/
scan in order to pair with the speaker.
 When the device has successfully paired with the speaker,
the speaker will say "Bluetooth Connected" and the LED
will turn solid.
NOTE: If the speaker does not pair with your device, turn
the power to the speaker off, wait 5 seconds, then turn
the power back on and start the pairing process again.
NOTE: When a device is paired to the speaker, information
for connecting to the device is saved in the speaker's
memory.
 To disconnect the BLUETOOTH
and hold the PLAY/PAUSE button for three seconds.
When the device is disconnected, the speaker will say
"BLUETOOTH disconected", the LED will flash, and the
®
speaker will search for a BLUETOOTH
NOTE: The speaker will not automatically connect to the
device it was just disconnected from.
ENABLED DEVICE
®
enabled devices
®
enabled device, press
®
signal.
®
®