Instruction Manual - Kerbl BA-1275 Manual De Instrucciones

Specific Operating Instructions
1
2
6
7
a.) Installation
The unit must, as a rule, be installed vertically with the connections at the bottom and, if possible, protected
against rain, see above picture, left side. In case of wall mounting, it must be mounted against a fireproof wall.
For outdoor installation, a zinc-plated metal casing can be used. This accessory (part No. 44656) protects the
unit and also accommodates the accumulator.
b.) Functional description of the unit
Put unit into service WITHOUT fence and earthing. When connecting the 12V accumulator, be sure to
observe the correct polarities (red + and black -). If the fence light (1) flashes green, the unit is ready for use. If
in addition the accumulator light (2) flashes red, check the 12V accumulator for correct voltage. If the fence
light (1) does not flash, check the polarity of the 12V connecting cable on the accumulator or have the unit
checked by a technician. When operating the unit with solar module or mains adapter, first remove the
protective cover (4).
Switch positions: 0 = OFF;
I = reduced current consumption and output power
II = maximum output power and current consumption
c.) Functional description with connected fence system ( fence + earth )
Accumulator Fence light
light (2) (1) flashes
flashes red green
YES
1
NO
2
NO
YES YES
3
YES
4
YES
5
6
NO
If the fence light (1) flashes faster than approx. once per second, the unit must be disconnected at once and checked by
a technician before it can be used again.
For increased running time, a number of Solar modules with support stands can be used. We recommend the use of a
wet accumulator at 12V-85Ah or 12V–110Ah. The accessories for this unit are obtainable through specialized dealers!
Mains adapter = Art.-Nr. 371012
!!!Attention: Earth electrodes are not included in the supply (use at least 3 earth electrodes approx. 1m long) !!!
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system regularly, in
accordance with the conditions of use, at least once per day.
visual check of the appliance and the fence system
-
- measurement of the minimum voltage of 2500V at each point of the fence
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, maintenance of battery
and accumulator, warranty terms and conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
Normal operation with 12V – wet
accumulator; alternatively, the appliance can
be operated with a mains adapter!
This energizer shall not be used
as an animal trainer (inside a barn).
Audible Output voltage
clicks
YES OK
see fault finding in the enclosed instruction
YES
NO
manual (Figure 2, p.5)!
YES
OK
see fault finding in the enclosed instruction
YES
NO
manual (Figure 2, p.5)!
No pulses, deep charge protection activated
NO NO
See b.) Functional description of the appliance, without fence and
NO NO
earth
8
1
2
4
3 2-step switch
5
4
3
5
6 Earth connection
7 Fence connection
8 Fastening holes
and:
3
Fence voltage
Indicator light
12V-ACCUMULATOR
indicator light
Socket for solar / mains
adapter + protective cover
12V battery connection
cable
( = 50%)
( = 100%)
12V accumulator
OK
OK
Charge or replace as
soon as possible
Charge or replace as
soon as possible
Charge or replace at
once
-EN-
Version : 2019.1