YUNEEC E90 Guia De Inicio Rapido página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
transformer stations, radio towers, mobile phone masts etc.), a strong wireless signal environment, no-fly zones, poor visibility and in the event of vision
impairments or other impacts on the pilot which are left unchecked etc.
Damage and/or injury brought about through a violation of the legal regulations for operating the model, in unsuitable weather conditions, e.g. rain,
wind, snow, hail, storms, hurricanes etc.
Damage and/or injury as well as violation of legal regulations caused by force majeure, e.g. collision, fire, explosion, flooding, tsunami, landslide,
avalanche, earthquake or other forces of nature.
Damage and/or injury as well as violation of legal regulations caused by the illegal or immoral use of the model, e.g. capturing videos or recording data
which infringes upon/harms the privacy of other people.
Damage and/or injury as well as violation of legal regulations caused by incorrect use of the batteries, protection systems, chargers or aircraft.
Consequential damage caused by the incorrect operation of any kind of system components and accessory parts, especially memory cards, whereby
image or video material from the camera can become defect.
Any non-compliance with legal obligations, personal injury, material damage and environmental damage caused by use and a failure to comply with
the local laws and regulations.
Damage and/or injury as well as violation of legal regulations caused by hazardous use without sufficient practical experience.
Damage and/or injury as well as violation of legal regulations caused by flying in legally defined no-fly zones.
Further losses which do not fall within the scope of use defined by Yuneec Electric Aviation as improper.
This product is designed for both professional use and personal, private use. The national and international laws and regulations in force as the time
of taking off must be adhered to.
Regulation Information
FCC Statement
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
RF Exposure Warning
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
IC Radiation Exposure Statement for Canada
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Le
présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment.Cet équipement respecte les limites
d'exposition aux rayonnements IC définies pour un environnement non contrôlé
NCC Warning Statement
Article 12
Without permission, any company, firm or user shall not alter the frequency, increase the power, or change the characteristics and functions of the
original design of the certified lower power frequency electric machinery.
Article 14
The application of low power frequency electric machineries shall not affect the navigation safety nor interfere a legal communication, if an interfer-
ence is found, the service will be suspended until improvement is made and the interference no longer exists.
CE Warning Statement
This device meets the EU requirements on the limitation of the general public to electromagnetic fields by way of health protection.
EU Operation Frequency (The Maximum Transmitted Power)
5G Wifi: 5560-5580MHz (27dBm), 5680-5700MHz (27dBm)
EU Compliance Statement
Hereby, Yuneec International (China) Co., Ltd. declares that this device is in compliance with the essential requirements and other relevant provisions
of the RED Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address:
http://yune.ec/de-downloads.
Please visit the address above and enter into corresponding product page.

Publicidad

Tabla de contenido
loading

Tabla de contenido