Orion HCCA1002 Manual De Propietario página 7

FULL FLUSH MOUNTING
step 1: Determine where the tweeter will be mounted . Make sure there is a flat
area large enough for the tweeter and no obstructions behind the area .
step 2: Using supplied template mark with a pen the hole needed for the tweeter .
step 3: be sure the hole is large enough for the tweeter housing .
step 4: Cut the hole for the tweeter . When using factory locations, this step can be
skipped . a hole can be cut either with a pair of metal tin snips or a 2" hole
saw for soft materials or 2-1/8" hole saw for hard materials .
WARNING: Check for clearance of window mechanisms and electrical wires
befoRe you drill .
step 5: Install tweeter in flush mount housing .
step 6: Connect the speaker wires observing the correct polarity .
step 7: Install tweeter and housing in the hole cut for mounting, so that the trim
ring is flat with the front of the surface .
step 8: Use the supplied pressure ring to secure the housing to the surface .
FLUSH
MOUNT
TRIM RING
Figure 2
Figura 2
Abbildung 2
© 2012 MD Audio Engineering—all rights reserved
FLUSH MOUNT
TWEETER
ASSEMBLY
TWEETER
CUP
TWEETER WIRE PANEL
PRESSURE
RING
WIRING HARNESS
5