Instruction Manual; Wire Rope Cutter - NORDFOREST 42-297 Manual De Instrucciones

EN
Use
• Release hand lever 1 by turning locking knob 2 in position
ON.
• Hold handle 1 fully open and press down the retaining pawl
3. It is now possible to turn the pivoted blade 4 as required.
• Insert the wire rope and turn the pivoted blade 4 until the
edge of the blade rests on the cable. Do not cut angularly!
• Squeeze the handles to manually operate the pivoted blade
4 during the cutting process.
• Releasing the pivoted blade 4 is possible during cutting
proceeding as follows: Open handles 1 until the block, keep
the retaining pawl 3 pressed. Turn back the pivoted blade 4.
In some cases release the retaining pawl 3 by a blow (with
an plastic hammer) on the pivoted blade 4 (see point x).
• Lock lever 1 by turning the locking knob 2 in position OFF
during squeezing both handles.
Maintenance
• Oil movable parts.
• Brush ratchet teeth.
General safety instructions
Please read the instruction manual before using the tool and
use the tool only for the specifi ed application. Please obser-
ve the instructions during the use and keep the safety inst-
ructions next to the tool. NORDFOREST assumes no liability
for damages or injuries caused by unsafe use of the tool,
defective maintenance or faulty application. The tool must
only be used by instructed professionals. The tool must only
be repaired from the manufacturer. For works of external
staff we assume no liability. Use only original NORDFOREST
spare parts! If not, claims of the warranty declaration expires.
15-275_SCS13_Nordforest.indd 5 15-275_SCS13_Nordforest.indd 5

Instruction manual

Wire rope cutter 42-297

For fl exible wire ropes up to max. Ø 13 mm.
Stainless and high compressed wire ropes up to
max. Ø 10 mm
Do not live working!
Switch off current!
No extremities near the blades!
5
10.11.2015 10:31:38 10.11.2015 10:31:38