Maintenance; Engine Oil Changing Instructions; Maintenance Schedule; Information - Maxus MX5222 Manual De Instrucciones Y Lista De Piezas

Lavadoras apresion con motor a gasolina
Ocultar thumbs Ver también para MX5222:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer. Refer to the
schedule for recommended maintenance. If you operate the
pressure washer in dusty conditions, perform maintenance
checks more often.

ENGINE OIL CHANGING INSTRUCTIONS

Drain the engine oil when the engine is warm. Warm oil drains
quickly and completely.
1. Turn the fuel valve to the OFF position to reduce the
possibility of fuel leakage.
2. Place a suitable container next to the engine to catch the
used oil.
3. Remove the oil filler cap/dipstick and drain the oil into the
container by tipping the engine toward the oil filler neck.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw into the trash, oust it on the ground,
or pour it down a drain.
4. With the engine in a level position, fill to the upper limit
mark on the dipstick with the recommended oil.

MAINTENANCE SCHEDULE

Maintenance Schedule
Daily
After first 5 hours of
operation
Every 25 hours of
operation
Every 50 hours of
operation
Each 100 hours of
operation or every 3
months
Action needed
• Check water inlet screen and
filter.
• Check engine oil levels. Fill as
necessary.
• Check gasoline level. Fill as
necessary.
• Change engine break-in oil. Use
10W-30 automotive detergent
oil. See your Honda Owner's
manual for specific information.
• Change oil if operating under
heavy load or high ambient
temperature.
• Clean or replace paper air
cleaner cartridge. Tap gently to
remove dirt.
• Change oil.
• Replace spark plug.
• Replace paper air cleaner
cartridge.
• Change engine oil.
Oil filler neck
Figure 20 - Oil drain and fill locations
Running the engine with a low oil level can
cause engine damage.
5. Reinstall the oil filler cap/dipstick securely.
PUMP OIL CHANGING INSTRUCTIONS
Changing or refilling the oil in the pump requires removal of the
pump from the engine and should not be required unless oil
has leaked out due to worn or damaged oil seals in the pump. If
oil has leaked out of the pump, bring the pressure washer to a
certified Maxus service center for repair.
TECHNICAL AND CONSUMER INFORMATION
Horizontal Oriented Pressure Washers
Engine Oil Type
Engine Oil Capacity
Honda Engines
Engine Fuel Capacity
Honda Engines
Pump Oil Type
Wobble Pumps
Pump Oil Capacity
Vertical Wobble Pumps
Pump Detergent Suction
Water to detergent ratio
Water Supply Requirements
Minimum inlet pressure
Maximum inlet pressure
Maximum inlet temperature
Minimum inlet flow rate
Inlet garden hose size
Maximum inlet garden hose
length
Model MX5222
Oil filler
cap/dipstick
Upper limit
SAE 10W-30
SAE 30W (Above 60° F)
18.5 fl. oz.
0.29 gallons
80w90 gear oil
2.7 fl. oz.
8 to 1 (12% detergent)
20 psi
100 psi
100° F
5 gpm
5/8 inch I.D.
50 feet
15

Publicidad

Tabla de contenido
loading

Tabla de contenido