Todo el servicio que no sea el mantenimiento del usuario se llevará a cabo en un Centro de Servicio Autorizado McCulloch. Los daños o las condiciones que hagan inoperable este producto debido a las prácticas inadecuadas de mantenimiento anularán la garantía del fabricante.
Página 3
1 - GENERAL INFORMATION - RENSEIGNMENTS GENERAUX - IMPORTANT SAFETY INSTRUCTIONS INFORMACION GENERAL INSTRUCTIONS DE SECURITE IMPOR- TANTES - INSTRUCCIONES DE SEGURI- DAD IMPORTANTES PLEASE READ - SAVE THESE INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed to assure maximum safety and opti- mum performance.
Página 4
6. Wear safety goggles. WARNING: 7. Do not use acids, solvents, or any flammable material in this product. These products can cause physical injuries to the operator and irreversible damage to the machine. To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. 8.
Página 5
3. Le débit peut etre déterminé en faisant couler de l'eau pendant une minute dans un récipient vide de 5 gallons. McCulloch. La garantie du fabricant sera nulle et non avenue si des dommages ou des conditions causés par de 4.
Página 6
• INTERNATIONAL SYMBOLS INSTRUCCIONES DE ENSAMBLE 3- ASSEMBLY INSTRUCTIONS - 1. Read the User Manual (Figure 2-1). INSTRUCCIONES DE ENSAMBLE 2. Use of these personal safety items is highly recommended to reduce the risk of accidental injury (Figure 2-2). SAVE THESE INSTRUCTIONS •...
Página 7
4- OPERATING INSTRUCTIONS - INSTRUCTIONS D’UTILISATION INSTRUCCIONES DE OPERACION Fig. 1H Fig. 1G Fig. 1F 5. Connect the screw-type female connector (H) to male connector (E), which is linked to garden hose. (Fig. 1F) 6. Connect garden hose to the cold water source and turn water on completely. Inspect connections for leakages. Fig.
Página 8
WARNING 5- MAINTENANCE INSTRUCTIONS- ENTRETIEN- INSTRUCCIONES DE MANTENIMIENTO Any other servicing should be performed by an authorized sevice personnel. CAUTION • CLEANING AND MAINTENANCE Before performing any work on the machine, ensure it is unplugged from the Disconnect power cord before filling chemical tank. Chemical tank and supply lines must be flushed with water after main electrical supply and the water pressure has been released.
TROUBLE SHOOTING Fault Cause Analysis Corrective Action • Pressure washer not plugged in. • Plug in pressure washer. • Circuit breaker has tripped or • Reset breaker or replace fuse. When switch "I" the machine fuse is blown. will not start working •...