FUXON R-232 EB Instrucciones De Funcionamiento página 3

Technical facts and references
With red COB LED (48 pcs)
u
Tested and approved in accordance with
u
the German Road Traffic Licensing Regula-
tions (StVZO)
The reflector surface of the taillight must
u
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
Nominal performance: 2,5 W
u
Input voltage: 6V (6-12V) DC AC
u
PLEASE NOTE If an LED fails, the entire light
unit must be replaced!
Connecting the rear-light:
Pull the + and – slide-appliance out of the housing (1), insert the designated cables in the
particular port and then push the slide-appliance back into the housing again (2).
1
Slide
Power cable + Power cable -
Atachment of the rear-light:
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated
u
screws,nuts and washers to the carrier of
the bicycle.
When attaching the tail light, make sure
u
that the screws are tightened so tightly
that the light can not.
3
REAR LIGHT »R-232 EB«
Important:
The 6-12 V DC version is marked with the
symbol DC AC. It should be noted that the
use of the 6-12 V DC AC version is only
permitted for bicycles with electric assisted
pedalling (e-bikes) if, following a discharge-
based shut-down of the support drive, an
uninterrupted power supply to the lighting
system is ensured for at least two hours, or
if the drive motor can be used temporarily
as a generator in order to continue to supply
power to the lighting system.
The light is switched on/off using the bike
control unit with pedal assistance.
2
Slide
Power cable +
48 COB LED
COB ring red (48 pcs.)
vehicle`s longi-
tudinal axis
Power cable -
Input: DC AC
Powersupply
Before every
journey, en-
sure that the
headlight is
not covered.
GB