The First Years Y1058 Manual De Instrucciones página 4

HEAT BOTTLE / JAR:
1. Place unit on a flat surface and plug into AC outlet.
2. Fill water vial with room temperature water to
recommended time marking (minutes) listed in
WATER MEASURING GUIDE.
The time listed is a recommendation ONLY.
The vial markings DO NOT provide exact durations.
3. Pour water from vial into the warming chamber.
4. Always place basket into warming chamber first
before adding bottle or jar.
Do not place bottle/jar directly onto heating element.
A. Wide neck bottle: Place bottle into basket
NOTE: When heating GumDrop wide neck
bottom vent bottle remove hood while heating.
B. Slim neck bottle (straight or angled): Place
adapter ring on top of basket and then place bottle
into basket.
C. Disposable bottle or baby food jar: Insert into lift
out basket and then place into basket.
NOTE: Remove lid of baby food jar before
inserting into lift out basket.
5. Press the ON button. Button will light to indicate that
unit is heating.
6. When the light turns off the warming cycle is
complete. The heater shuts off automatically.
7. Remove bottle/jar from chamber and allow it to cool
before handling.
Adjust the level of water (minute marking) in the water
vial as follows:
If contents are too hot – use less water in the water vial.
If contents are too cool – use more water in the water vial.
ALWAYS shake bottle / stir food well and test
temperature of contents before giving bottle to child.
8. Wait 10 minutes before heating a second bottle to
avoid overheating.
COOL:
1. Fill freezer bottle with water to max fill line.
2. Place in freezer until frozen solid.
TO USE