Publicidad
Idiomas disponibles
Idiomas disponibles
LEDS
EVENT
Runtime Remaining: 100%
Runtime Remaining: 75%
Runtime Remaining: 50%
Runtime Remaining: 25%.
All Command Confirmations
All Error Confirmations
Arming/Locking While Trigger
is Open
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
FTX2400R_QuickCard 130616.indd 2
All manuals and user guides at all-guides.com
QUICK START CARD
REMOTE
LED
LEDS
DURATION
CHIRPS
6 Times
Once Every
5 Seconds
N/A
1 or 2
1 or 2
3 Times
3 Times
START ERROR CODES
PARKING LIGHT FLASHES
3 then 1
1: Motor running
3 then 2
2: Key in ignition on position
3: Door open
3 then 3
3 then 4
4: Trunk open
3 then 5
5: Foot brake on
3 then 6
6: Hood open
7: Reservation off
3 then 7
(manual transmission only)
3 then 8
8: Tach or voltage sensing failure
3 then 9
9: FT-DAS sensor shutdown
3 then 10
10: System is in Valet Mode
Register online at www.compustar.com within 10 days of
purchase to activate your new remote's warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user's manual.
FTX2400R-SS
REMOTE START ERROR
(manual transmission only)
Firstech, LLC. | 2
2013/6/18 8:32:21
Publicidad
