Connection - D+H LA 35 Manual Del Usuario

Technical data
Type
Power supply
Nominal current
Nominal force
Nominal locking force
Service time
Duty cycle
Housing
Ingress protection
Temp. range
Fire stability
Emission sound pressure level LpA ≤ 70 dB(A)
Nominal stroke length* / **
Additional functions **
* adjustable with PLP 1
Normal operation =
SHEV- fast running =
Forces LA 35 LA 85
OPEN 300 N 800 N
CR III 300 N 800 N
CR II 300 N 800 N
CR I 300 N 800 N
All forces + app. 20 % switch-off reserve (temporary)
Connection: page 10
Mounting informations
- Eyebolt has to be adjusted so, that the drive is
disconnected with closed louvre through it's inside
stop position damping. Brackets can be damaged
by to rigid adjustment!
- A programming should be done before
installation, because the drives can only be
programmed individually connected
Shifting of drive cable
Disconnect drive from electric voltage!
99.950.99 1.1/04/16
LA 35
24 V DC, ±15%
0,5 A
300 N
1100 N
>20 000 double strokes
30 % (with cycle time 10 minutes)
Aluminium powder-coated (~RAL 9006), polycarbonate
IP 65 ("-W" = IP 54)
-5 ... +75°C
30 min / 300°C
See type plate
Closing edge protection activated (3 stroke repeatings)
** programmable with PLP 1 and SCS
LA 105 LA 155
1000 N 1500 N
1000 N 1000 N
1000 N 1000 N
800 N 800 N
LA 85 LA 105
24 V DC, ±15% 24 V DC, ±15%
1,0 A 1,2 A
800 N 1000 N
Running speed and forces
Shifting of Motor
1. Move out toothed rack about 10 ... 20mm.
Disconnect drive from electric Voltage!
2. Take off drive unit and shift
3. Attention! Moving direction of drive is changed.
Drive cable on the shutdown pcb, switch
red (+) with black (-).
10 ... 20 mm
English
LA 155
24 V DC, ±15%
1,4 A
1500 N
5/12
LA 35-85-105