Far Tools DP 16E Manual Del Usuario página 27

Settings of the machine
FIG. F
Belt tension
01
-
02
replacing consumables
FIG. G
Accessories available
01
-
02
Maintenance, recommendations and advice
The use of suitable accessories in good condition will ensure the machine operates optimally
01
Spindle lubrication
02
To avoid rust, grease machined metal parts ( table, column, etc.)
03
Check the condition of the belts regularly
04
Lubricate the bit when drilling with a mixture of soluble oil and water
05
Adapt the rotation speed of the chuck to the diameter of the drill:
06
- Small diameter = high speed
- Large diameter = low speed
111202-Manual-E.indd 27
03
04
3000
2800 min -1 = 3 mm
2500
2000
1500
1000
500
0
5 10 15
© FAR GROUP EUROPE
Setting the drawback spring
-
300 min -1 = 30 mm
20 25 30
ø (mm)
EN
11/02/11 11:00:01