Tires; Body, Deck And Upholstery - Scag Freedom SFZ Manual Del Operador

3. Secure the cutter blades to prevent them from rotating,
(Use the optional Blade Buddy tool, P/N 9212, to assist
in securing the cutter blades), remove the blade attaching
bolt. Remove the cutter blade, bolt, lockwasher and
flatwasher from the spindle shaft. (Figure 7-8).
4. To install the new cutter blade, put the lockwasher and
flatwasher onto the blade bolt and slide the bolt into the
hole in the cutter blade.
CUTTER BLADE
LOCKWASHER
5/8-11 x 1-1/2" HEX HEAD BOLT
TORQUE TO 75 FT/LBS
Figure 7-8 Blade Replacement
-NOTE-
Be sure that the blade is installed with the lift wing
toward the top of the cutter deck.
5. Install the cutter blade onto the cutter spindle shaft.
Secure the blades from rotating and torque to 75 ft/lbs.
(See Figure 7-8).

7.9 TIRES

Check the tire pressures after every 8 hours of operation or
daily.
7.10 BODY, DECK, AND UPHOLSTERY
Do not wash any portion of the equipment
while it is hot. Do not wash the engine; use
compressed air.
1. After each use, wash the mower and cutter deck. Use
2. Do not spray electrical components.
FLATWASHER
3. Use a mild soap solution or a vinyl/rubber cleaner to
4. Repair damaged metal surfaces using Scag touch-up
34
Caster Wheels ......................................... 25 PSI
Drive Wheels .......................................... 8 PSI
CAUTION:
cold water and automotive cleaners. Do not use
pressure cleaners.
clean the seat.
paint (P/N 48521) available from your authorized Scag
dealer. Wax the mower with an automotive paint wax
for maximum paint protection.
Section 7