05 | MOUNTING ONTO FEEDER CONTAINER
Mount the feeder onto a suitable feed container (optionally available in
stores) by screwing the supplied screw nuts (14) through the 4 mounting
holes (13).
06 | INSERTING THE BATTERY BATTERY OPTIONAL
CAUTION
Only operate with a suitable, rechargeable 6V
4,5 Ah lead battery!
Optionally available from DÖRR:
Lead Battery 6V 4,5Ah
Item-No. 204349
1. Open the battery compartment (4) pressing the compartment cover (5)
upward and drawing the flaps outwards.
2. Slide the plugs of the battery cables (6) onto the corresponding battery
contacts.
Make sure to respect the correct polarity: red
CAUTION
cable (+) to red battery contact, black cable (-) to black
battery contact.
3. Place the battery in the battery compartment (4) and close the com-
partment cover (5).
Note
When changing the battery, we suggest leaving the feeder main switch
(11) in position ON in order to avoid the loss of settings.
Please note that batteries often are not fully charged when purchased.
We recommend checking and if necessary charging the battery before
starting operation. Use a customary charger.
Drilling template on page 14/15
SAFETY HINTS FOR RECHARGEABLE BATTERIES
Only use high-quality batteries of popular brands. When inserting the bat-
tery please respect the correct polarity (+/-). Please remove battery when
device is not in use for a long period of time. Do not throw the batteries
into fi re, do not short-circuit and do not disassemble them – risk of explo-
sion! Remove leaking batteries from the device immediately. Risk of battery
acid burn! Clean the contacts before inserting fresh batteries. In case of
contact with battery acid, rinse the a ected area immediately with water
and contact a doctor. Batteries can be dangerous to life if swallowed. Keep
batteries away from small children and pets. Do not dispose of batteries in
household waste (see also capture "Disposal of Batteries/Accumulators").
09