RL ANDREAS Manual De Instrucciones página 9

Keep all safety instructions and instructions for future reference.
Care
Only clean the device when it is switched off and with the mains plug unplugged. Use a soft, lint-free cloth. This can be
slightly moistened if necessary. Avoid contact with electrical components and moisture. After cleaning, allow the device to
dry completely before putting it back into operation. Do not use aggressive cleaning agents.
Commissioning
Before commissioning, please check the correct installation of the protective screens again; there is a risk of injury if they
are not installed correctly. Generally, the device may only be operated when completely assembled. Make sure that the
connected supply cable is free of damage. Never operate a device with a defective supply cable. There is a risk of electric
shock. Position the device upright and stable. When positioning the fan, make sure that curtains or other objects do not
obstruct the air flow. Insert the power plug into a properly fused power socket.
Assembly
1. Front Guard
2. Blade spinner
3. Fan Blade
4. Guard Frame
5. Nut
6. Back Guard
7. Fan Head Motor
8. Head angle knob
9. Flexible Hose
10. Indicator
11. Control Buttons
12. Thumb Screws
13. Power Cord
14. Support Tubes
15. Base with Cover
16. Mist vent
17. Water tank
18. Water tank cover
19. Nebulizer
20. Mist controller
21. Base
22. Washers
23. Screws
I) Base
a) Place the cover onto the base.
b) Take the two support tubes and remove the screws from the ends. Enter the two tube ends into the holes of the cover.
c) Fix the tubes with washer and screws.
II ) Fan Head / Indicator
a) Loosen the two Thumb Screws (12) located on the back of the Indicator (10). Do not fully unscrew otherwise the two
nuts will fall off!
b) Locate the two holes of the Indicator onto the two Support Tubes (14) and push down until it stops.
c) Tighten the two Thumb Screws (12).