Warner 11066 Manual Del Usuario página 4

1
Portable Stand Assembly:
Step 1. Attach light head fixtures to mounting bar using (2) plastic mounting knobs.
Step 2. Attach handle to mounting bar using (2) plastic mounting knobs.
Step 3. Attach cord to handle with screw.
2
Set Up the Tripod Stand:
Loosen locking knob and pull
legs away from center pole
(out) until all three legs make
contact with the floor.
Retighten the locking knob
when legs are firmly in place.
3
Attach Portable Stand to Tripod Stand:
Pinch the red locking buttons inward. Align the holes on the underside of the light bar with
the two metal locking tabs on the tripod stand. Release the locking buttons to lock the light
bar in place.
Step 2
Step 1
Extending the Tripod Stand
from 3 Feet to 5 Feet:
Unlock the locking
collars by twisting
collar counterclock-
wise. Lift the pole
above the collar and
twist the collar
clockwise until tight.
WARNING: Make sure the portable light bar
is connected completely to the locking tabs
on the tripod stand. Lift the portable light
handle to confirm. Failure to complete
this step may cause injury or damage to
the lights.
4
Step 3