Toyotomi Zibro RS - 122 Instrucciones De Uso página 11

GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL.
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank
ignite the heater (refer to Section B, Fig. I).
3
Insert the batteries into the battery holder µ
(refer to Section A, Fig. F).
4
Check whether the combustion chamber » is fully upright (refer
to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment knob ·
as far to the right as possible
(refer to Section C, Fig. L).
6
After igniting the heater it will take 30 minutes before you can
check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
•
As a fire precaution, the tank must be filled either when the heater has been
switched off or in another room than the room where the heater is installed.
•
Always ensure that the tank is closed properly after filling it at a safe distance from
all sources of heat and open flames (see Section B).
•
The first time you ignite your heater it will smell like 'new' for a short time.
•
Store all fuel containers with their original caps and seals in a cool and dark place.
•
Fuel ages. Use new fuel at the start of every heating season.
•
Only use high quality and water-free pure paraffin in accordance with local
legislation (TOYOTOMI fuel).
•
Before changing brands and/or types of fuel make sure that the mobile heater first
completely empties all of the remaining fuel inside the heater.
and wait 30 minutes before you
4
3