•
When setting up the camera, allow approximately 10 to 20 seconds for the camera to acquire a
signal.
•
In setup the camera will shut down automatically after 3 minutes if no operation is done. Please
turn on the power again to re-activate the camera.
3. General Guidelines
•
Refer to the Velleman
•
All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession, use or
failure of this product.
•
Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
Camera
1
display
2
IR LEDs
3
lens
4
up/video
5
down/capture
6
front sensor
7
OK/shot
8
menu
9
right
Tripod
1
screw
2
locking nut
3
pivot bolts
4
drill holes
V. 01 – 17/06/2020
®
Service and Quality Warranty on www.velleman.eu.
WLC002
10
playback
11
battery compartment
12
speaker
13
mode
14
USB jack
15
card slot
16
power input
17
tripod connection
5
hex screw
6
wall plugs
7
screws
5
©Velleman nv