Utility; Isplay; Estore - Numark D2 Director Manual De Referencia

UTILITY

The Utility button gives access to System information and
settings.
The main utility work area displays the unit serial number. This
information is useful if you need to contact Customer Care or
check for firmware updates at the Numark web site.
Tip: It is strongly advised that you periodically compare your
firmware version with that available at the Numark web site,
and install any more recent version that may be available.
New software will be posted regularly to add features and fix
problems. See "D2 Software Upgrades" section for details.
Further utility screens are accessed from the menu as follows.
Display
From here the display brightness can be adjusted.
Also, a scale of shades from black to white is shown on screen as
an aid to setting the display contrast. Adjust the contrast by
rotating the Display Contrast knob located to the left of the
display until the left most segment of the scale is black, the right
most is white, and three shades can be identified in between.
Restore
This operation will reset the unit to default settings. Select
Restore to proceed, or press Utilty or another function button to
cancel. Just to be really sure, you will be asked one more time if
this is something you want to do. Select Yes or No as
appropriate.
The default settings are:
Pitch Range 12%
Track Loading - Manual
Time Display - Elapsed
Fader Start - Off
Display Brightness - Mid way
Note that the calibration (see below) will not be reset by this operation.
25