Before you start
1. Wire fixing clips
2. Shaft tube
1. Wire end
2. Nuts
With nylon line cutting head
1. Shield
3. Throttle wire
3. Carburettor
2. Bolt
To eliminate loosening of throttle wire fix it to shaft tube (2 places)
and to right hand U-handle (1 place) with wire fixing clips.
After assembly, adjust the play of wire end on carburettor
side to 1 mm - 2 mm.
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Nylon line cutting head
Type: Z5
Thread: Left-hand thread M10×1.25 pitch
Replacing nylon line
Shut down trimmer engine without fail and make sure ny-
lon line cutting head has stopped rotating before starting
replacement procedure.
18
CAUTION
DANGER