Product Description - Dörr W-31 Manual De Instrucciones

02 | PRODUCT DESCRIPTION

Multifunctional work light for workshop, camping, hunting and outdoor use.
Brightness adjustable in 2 levels (100%, 30%) and stepless dimming
•
Additional power bank function with 6000 mAh
•
Cordless operation
•
Built-in Lithium-Ion battery, rechargeable via supplied power adapter
•
Robust plastic housing
•
Swivel-mounted base including magnet
•
2 fold-out hook for hanging
•
2 additional magnets on the back of the housing
•
03 | NOMENCLATURE
01 Main LED
02 Base
03 Magnet
04 Auxiliary LED
05 Fold-out hook for hanging (2x)
06 Magnet (2x)
07 Charging/Power indicator
08 Charging socket cover
09 Charging socket
10 USB output
11 On/Off button
12 USB adapter
13 USB charging cable
04 | BUILT-IN LI-ION BATTERY
Before first use of the work light, please fully charge the built-in Li-Ion battery:
Connect the USB charging cable (13) to the USB charger (12). Open the charging socket cover (8) and connect the USB charging cable (13) to the charging socket (9). Plug the
USB adapter (12) into a power outlet. The work light will be charged. This will be shown with flashing LEDs (7). When the built-in Li-Ion battery is fully charged, the blue LEDs
of the charging indicator (7) will light up constantly. Unplug the USB charging cable (13) from the work light. Disconnect the USB adapter (12) from power supply. Close the
charging socket cover (8) again.
Alternatively, you may charge the work light by every power source with USB socket (e.g. PC, Laptop, 12 V car adapter).
05 | OPERATION
<5
Press On/Off button (11)
Sec.
once
Turn on
30% brightness
(Main LED)
NOTE
When the work light is set to a brightness level longer than 5 seconds and you press On/Off button (11) it will turn off directly. In order to use the dimming function, press and
hold the On/Off button (11). This works for the main LED (1) as well as for the auxiliary LED (4). Turn on the desired LED as described above. As long as you press and hold the
On/Off button (11), the respective LED will alternately be dimmed brighter and dimmed darker until you release the On/Off button (11). The work light will flash up 2 times each
time the maximum and minimum dimming level is reached.
<5
Press On/Off button (11) Press On/Off button (11)
Sec.
2nd time
100% brightness
(Main LED)
<5
Press On/Off button (11)
Sec.
3rd time
100% brightness
(LED auxiliary light)
07
4th time
Off