Attaching The Arms To The Display - Philips SQM5312/27 Manual Del Usario

Using the enclosed mounting template,
2
place the diagram against the wall and mark
six locations on the wall where the mount
is to be Installed.
With the help of another person, place the
3
mount against the wall and level it using the
bubble guide.
While another person holds the mount in
4
place, mark six locations on the wall where
the mount is to be installed.
Set the mount aside and drill a 3/8" (10
5
mm) pilot hole at each marked location.
Remove any excess dust from the holes.
Insert a concrete anchor (P) into each hole
6
so that it is flush with the concrete surface.
A hammer can be used to lightly tap the
anchors into place if necessary.
Place the mount back against the wall and
7
secure it using the lag bolts (Q) and lag bolt
washers (R) provided. Do not over-tighten
these bolts and do not release the mount
until all bolts are in place.
Once all (6) lag bolts are in place you must
8
tighten each one. Be sure not to over
tighten.
D
Note
If the concrete wall is covered
by a layer of plaster or drywall,
the concrete anchor must pass
completely through the layer to rest
flush with the concrete surface.
6
2
2
3.3 Attaching the arms to the display
B
Warning
Use extra care during this part of the
installation. Avoid laying your display
face down if possible as it may damage
the viewing surface.
Examine the back of your television.
1
If the back of your display is flat: You
will be using one of the shorter bolts from
the hardware kit.
If the back of your display is curved
or recessed: You will be using one of the
longer bolts and a spacer.
Determine the correct diameter bolt to
2
use by trying one bolt each from Bags 1
- 4 of the hardware kit. Do not force any
of the bolts – if you feel resistance stop
immediately to avoid damaging your display.
3
4
3
4