LEMAN PSP026 Manual De Instrucciones página 23

NOTE:
When using tools such as bull points, drill bits, etc., make sure to use the genuine parts designates by our
company.
(1) Clean and lightly grease the shank portion (14) of the drill bit (15).
(2) Insert the drill bit in a twisting manner into the tool holder until it latches itself (Fig.2)
(3) Pull the drill bit to make sure it is locked completely.
(4) To remove the drill bit, fully pull the flex sheath (2) in the direction of the arrow and pull out the drill bit
(Fig.3).
5. Confirm the direction of bit rotation (Fig.4)
(1) When the switch reversing bar (12) turn to the "R" direction, the drill will clockwise rotate.
(2) When the switch reversing bar (12) turn to the "L" direction, the drill will anticlockwise rotate.
6. Auxiliary handle (Fig.1)
CAUTION:
Operate your power tool only with the auxiliary handle.
NOTE:
The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
(1) Turn the bottom part of the auxiliary handle (7) in counterclockwise direction and swivel the auxiliary handle
to the desired position.
(2) Retighten the bottom part of the auxiliary handle (7) by turning in clockwise direction.
Pay attention that the band of the auxiliary handle is positioned on the front housing as intended for.
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill
bits and other various parts are installed or removed. The power switch should also be turned off during a work
break and after work.
1. Switch operation
The rotation speed of the drill bit can be controlled steplessly by varying the amount that the switch is pilled.
Speed is low when the switch is pulled slightly and increases as the switch is pulled more.
Continuous operation may be attained by pulling the switch and depressing the locked Pushbutton.
To turn the switch OFF, pull the switch again to disengage the locked Pushbutton, and release the switch to its
original position.
NOTE:
The switch can only be pulled in halfway during reverse and rotates at half the speed of forward operation.
The switch locked Pushbutton is unusable during reverse.
2. When drilling at "rotation + hammering":
(1) Switching to "rotation + hammering"
(a) Push the locked Pushbutton (4), release lock and turn the function knob (3).
(b) Align ▲ of the function knob and
(c) Release the locked Pushbutton to lock the function knob.
NOTE:
Turn the function knob (do not push the locked Pushbutton) to check if it is completely locked and make sure that it
does not turn.
(2) Mount the drill bit (15).
(3) Pull the switch after applying the drill bit tip to the drilling position (Fig.11).
(4) Pushing the rotary hammer forcibly is not necessary at all. Pushing slightly so that drill dust comes out
gradually is sufficient.
CAUTION:
Although this machine is equipped with a safety clutch, if the drill bit becomes bound in concrete or other material,
the resultant stoppage of the drill bit could cause the machine body to turn in reaction. Ensure that the main handle
and side handle are gripped firmly during operation.
3. Rotation only
(1) Push the locked Pushbutton (4), release lock and turn the function knob (3).
(2) Align ▲ of the function knob and
GB
HOW TO USE THE ROTARY HAMMER
of the Gear Case as illustrated in Fig.5.
of the Gear Case as illustrated in Fig.7
21