Echo BCLS-510ES Manual De Instrucciones página 35

1. Cylinder fins
Cleaning silencer
1. Silencer
Check fuel system
1. Fuel tank cap
2. Fuel grommet
Check spark plug
a: 0.6 - 0.7 mm
2. Air intake
3. Fuel pipe
Maintenance and care
Remove dust and dirt from between fins.
Before each use, remove accumulated debris from bottom en-
gine intake grille located between the fuel tank and starter.
Carbon deposits in silencer will cause a drop in engine output
and overheating. Spark arrestor screen must be checked pe-
riodically. Clean deposits from silencer.
IMPORTANT
Do not remove the silencer cover. If necessary, Please consult
your dealer.
Check before every use.
After refuelling, make sure fuel does not leak or exude from
around fuel pipe, fuel grommet or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using the machine immediately and request your dealer
to inspect or replace.
Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
Inspect electrode for wear.
Inspect insulator for oil or other deposits.
Replace plug if needed and tighten to 15 N·m - 17 N·m (150
kgf·cm to 170 kgf·cm).
33