Hama 00047773 Instrucciones De Uso página 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
2. Package Contents
• Power Strip
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commer-
cial use only.
• The product is intended for indoor use only.
• Use the product for its intended purpose only.
• Children are not permitted to play with the device.
• Protect the product from dirt, moisture and over-
heating, and only use it in a dry environment.
• The product may only be operated with the type
of power supply network described on the name
plate.
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• The overvoltage protector may be operated only on
a 16 A fused mains socket with a properly installed
protective conductor.
• Do not connect to extension cables, power strips
or adapters.
• Lay all cables so that they do not pose a tripping
hazard.
• Do not bend or crush the cable.
• Never connect multiple units of this product in
series.
• Disconnect the product from the network using the
power button – if this is not available, unplug the
power cord from the socket.
2
• Always pull directly on the plug when disconnect-
ing the cable, never on the cable itself.
• Do not continue to operate the device if it
becomes visibly damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to qualified
experts.
• If the device is used commercially, increased duty
of care requirements apply.
• Therefore, please observe the accident prevention
regulations of the German employer's liability
insurance association for electrical systems and
equipment. Please also observe all accident
prevention regulations from other applicable
employer's liability insurance associations and
accident insurance companies, as well as any legal
regulations applicable to the particular industry
and/or location.
4. Proper use
The built-in overvoltage protector is designed for
mains-related overvoltage caused by switching
processes or distant lightning strikes. Additional
measures must be taken to safeguard against direct
lightning strikes. Coarse protection (requirement
clause) must be provided for in the building's
electrical system. The primary intended purpose of
the product is to protect high-quality telephone and
computer systems and audio, video and satellite
devices.
5. Connection
All devices must be switched off before devices can
be connected. The overvoltage protector may be con-
nected only between the electrical consumer and an
earthed socket. In the operational state, the indicator
light for the overvoltage protector lights up.
Warning
If the indicator light is not lit after switching on,
the overvoltage protector is defective – it may no
longer be used and must be exchanged for a new
overvoltage protector.