Connect To The Internet Via Wi-Fi; Connect To The Internet Via A 3G Dongle - Lenco TAB-703 Manual Del Usuario

Connect to the internet via Wi-Fi

Connect to the internet via Wi
Open system settings by tapping on the "options" icon Open system settings by tapping on the
settings" in the menu.
Now go to the WIRELESS & NETWORKS menu, tap on, and hold Wi Now go to the WIRELESS & NETWORKS menu, tap
it to the right so that the slider changes to ON. The tablet will now start scanning for it to the right so that the slider changes to ON. The tablet will now start scanning for it to the right so that the slider changes to ON. The tablet will now start scanning for
networks.
Select your access point. Select your access point.
Enter the password (if required). Enter the password (if required).
Select connect.
If you have a "hidden network," select ADD NETWORK an If you have a "hidden network," select ADD NETWORK and follow the instructions on
the screen.

Connect to the internet via a 3G Dongle

Connect to the internet via a 3G Dongle
Important note: this tablet does not support every 3G Dongle. Check the this tablet does not support every 3G Dongle. Check the this tablet does not support every 3G Dongle. Check the
compatibility list to make sure you can use your 3G Dongle. compatibility list to make sure you can use your 3G Dongle.
Install the SIM card into the 3G Dongle. Install the SIM card into the 3G Dongle.
Connect the USB host cable to the Dongle. Connect the USB host cable to the Dongle.
Connect the 3G Dongle to the tablet. Connect the 3G Dongle to the tablet.
Open system settings by tapping on the "options" icon Open system settings by tapping on the
menu "system settings." ystem settings."
Select more...
Select mobile networks Select mobile networks
Switch on mobile data. To do this, mark the checkbox behind Switch on mobile data. To do this, mark the checkbox behind "data enabled."
Now you can configure the Dongle. Now you can configure the Dongle.
Note: This manual does not describe how to setup your Dongle because this : This manual does not describe how to setup your Dongle because this : This manual does not describe how to setup your Dongle because this
depends on the operator and the kind of Dongle or Dongle brand that is connected. depends on the operator and the kind of Dongle or Dongle brand that is connected. depends on the operator and the kind of Dongle or Dongle brand that is connected.
The symbol appears on the screen after connecting to a 3G network. symbol appears on the screen after connecting to a 3G network. symbol appears on the screen after connecting to a 3G network.
If the symbol is grey, the Dongle If the symbol is grey, the Dongle is scanning for a network (so it is not connected).
When data is being transferred, the following symbol is shown: When data is being transferred, the following symbol is shown:
is scanning for a network (so it is not connected).
11
and then select "system and then select
and hold Wi-Fi. Then move
d follow the instructions on
and then select in the and then select in the
"data enabled."
.