• Use the battery indicator lights to determine when to charge
your iON+ 24VBAT-LTE lithium-ion battery pack.
• You can "top-off" your battery pack's charge before or after
a long day of use.
Charging the Battery
1. Push the push lock buttons on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
Fig. 1
Battery pack
Battery lock button
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 5 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
turn off when the battery is fully charged. Please take care
not to leave the battery plugged into the charger. Switch
off or unplug the charger at the mains when charging is
complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Operation
This product is intended for indoor and outdoor illuminating
purpose. The flash function can also be used to call for help.
Read the whole manual before operating and adjusting the
product.
m
WARNING!
make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Starting the Spotlight
m
WARNING!
or animals and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam may result in
serious injury or vision loss.
1. Insert the battery into the battery compartment (Fig. 3).
Fig. 3
Battery
indicators
2. Grab and hold the handle grip. Squeeze the switch to
turn on the light. The switch will click and the light will
illuminate. When the light is on, release the switch (Fig. 4).
8
FIRE HAZARD. When disconnecting the
This charger does not automatically
Do not allow familiarity with products to
Do not direct the light beam at persons
Battery pack