Warnings And Precautions - velombra Condor Manual Del Usuario

WARNINGS AND PRECAUTIONS

PRELIMINARY CHECKS
When you receive the packaged goods, if assembly is not to be
carried out by the dealer, check that all materials are intact and
that no parts are missing.
If you should have any problems, contact the authorised dealer.
DISPOSAL OF PACKAGING MATERIALS
Divide the various packaging according to the material used
(cardboard, nylon, polystyrene etc.) and dispose of them
separately in compliance with the regulations in force.
GENERAL WARNINGS
Before undertaking any assembly, maintenance or cleaning
operations, make sure that you have fully understood the
indications in this manual.
All Velombra Srl products have a specific function described
in this manual. Any other use not envisaged here, the use of
non-original components, or any unauthorised tampering and/
or technical modification, relieves Velombra Srl of any liability
for harm to persons or animals, or damage to objects resulting
from such intervention.
Installers (fitters and electricians) must have specific expertise
as well as the attitudinal and the physical and mental
requirements to be able to carry out their tasks; they must also
respect the safety regulations in force.
16 of 70
SAFETY PRECAUTIONS
It is good practice to bear in mind that any moving component
can constitute a hazard.
During all maintenance and repair operations or product
registration, the electric supply must always be disconnected.
It is also advisable to place a warning sign over the mains
supply switch with the following phrase:
"DO NOT TOUCH: work in progress".
Ensure that no one is in the proximity of the awning prior to
reactivating it after maintenance.
Always check the operation and efficiency of the manual
and electric drives after maintenance. If any faults occur, stop
immediately and contact Velombra Srl technical support.
VELOMBRA SRL  USER MANUAL  CONDOR
DEMOLITION
On demolition, the parts should be sorted into plastic material
and electric components, which must be disposed of separately
in accordance with the regulations in force.
Metal parts should be divided up into stainless steel and other
non-ferrous metals or alloys, for correct recycling.
SAIL REPLACEMENT
If replacing the model 2010 sail (with reinforcement), both
sails must be replaced with model 2011 sails (without
reinforcement).
Rev. 7 - 06.2012