Transferring The Time - Grasslin talento taxxi Instrucciones De Uso

Transferring the time

From the PC to the handheld programming device
The time is transferred to the handheld programming device from the PC via the serial interface.
From the handheld programming device to the time switch
The time is transferred via the infrared interface from the handheld programming device to the relevant
time switch or is read out by the handheld programming device from the time switch.
1. Select "c lo" with the Prog. key.
2. Hold the handheld programming device directly on the two IR diodes (hold the handheld programming
device still during this operation)
3. Press the corresponding key twice, depending on the transfer direction – in or out
4. Press the key once. The transfer is prepared.
c lo and the assignment in or out flash alternately.
Z Z
5. Press the key again. The time is transferred.
An audible signal is output during transfer.
Z Z
If the time has been correctly transferred, c lo can be seen in the display.
Z Z
If the time has not been correctly transferred, there is a short audible signal and the
Z Z
corresponding error message Er x appears in the display.
EN
19