Delay Times - Dvd Only; Dolby Pro Logic; Connecting The Power Supply - Philips SACD1000 Instrucciones De Manejo

Delay times - DVD only

Your SACD player is set to correctly reproduce
synchronized Digital Surround Sound in a listening area
where the surround speakers are about 150cm nearer
to the listening position than the front speakers and the
center speaker is in line with the front speakers. To
adjust for other listening-area arrangements, adapt delay
times according to the following:
Digital Surround
Measure the distances in centimeters from the front
speaker plane and from the surround speaker plane to
the listening positioning plane.
Substract the surround distance from the front distance
and divide by 30. The result is the required Surround
Channel delay time in milliseconds.
If the center speaker is on the front speaker plane, no
center speaker delay is needed. You can adjust the delay
time in the "User Preference Settings". See Personal
preferences - Sound - Speaker Settings. If, however, it is
nearer to the listening position, measure the distance in
centimeters between the front and center speaker
planes and divide by 30. The result is the required
Center Channel delay time in milliseconds.
Digital Surround Delay
10
ms
12
10,5
9
7,5
6
4,5
3
1,5
0
0 1,5 3 4,5 6 7,5 9 10,5 12
Distance from front speakers (m)

Dolby Pro Logic

If the delay times for Surround Channel and Center
Channel are set for Digital Surround mode, the delay
times for Dolby Pro Logic mode will automatically be
calculated and set.
Pro Logic Surround Delay
12
10,5
9
7,5
6
4,5
3
1,5
0
0 1,5 3 4,5 6 7,5 9 10,5 12
Distance from front speakers (m)
5
ms
0 ms
0 ms
0 ms
0 ms
-5 ms
-10 ms
Differential
arrival time
Preferred
Acceptable
Not recommended
25 20
ms ms
15 ms
15 ms
15 ms
15 ms
10 ms
5 ms
Differential
arrival time
Preferred
Acceptable
Not recommended

Connecting the power supply

1 Check if the power voltage as shown on the type
plate (on the back of the player) corresponds to
your local power voltage. If not, adjust the voltage
selector (1) to match with your local power supply.
2 Plug the female end of the power cable supplied into
the Power connector POWER SUPPLY (2) on the
rear of the player.
3 Plug the male end of the cord into an AC outlet.
Note: When the player is in the STANDBY or OFF position, it
will still consume some power. If you wish to disconnect your
player completely from the power supply, pull the plug from
the AC Outlet.
Caution: Only qualified service personnel should
remove the cover or attempt to service this
device.
1
VO LT
AG E SE
LE CT OR
22 0-2
40 V
10 0-1
20 V
2
M AI N S
PREPARATION 21