Hisense RT32D6ASE Manual Del Usario página 9

Changing the door from the right side to the left.
The side at which the door opens can be
changed from the right side (as supplied) to
.
the left side, if the installation site requires.
Tools you will need:
8mm socket driver
.
cross-shaped screwdriver
.
Putty knife or thin-blade screwdriver
.
7mm wrench
Caution
To avoid to injury yourself and/or property,
we recommend someone assist you during
the door reversal process.
.Ensure the Appliance is unplugged and
empty.
.Following steps are generally
recommended
1. Stand the refrigerator, open the upper
door and remove the things in the door and
close it.
2. open the screw hole cove and the upper
hinge cover which is at the top right corner of
the refrigerator.
upper hinge
cover (right)
screw hole cover
3.Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver
or a spanner(please support the upper
door with your hand when doing it ).
special flange
selftapping screws
right upper hinge part
4.Remove the right upper hinge part and
screw hole cover place them on ,
smooth surface.
5.Remove upper door and place it on
smooth surface with panel upwards.
6. Loose screws used to fix middle hinge
and remove middle hinge. Then turn middle
hinge by 180. Take washer on axis and put
it on another end. Place it well for use.
7. Remove lower door and place panel
upwards on smooth surface.
8. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
Lower hinge part right
Front foot fixed board
Adjustable bottom feet part
Self tapping screws
Note: Before this step, you should lay the refrigerator
on it's back in order to gain access to the base, you
should rest it on soft foam packaging or similar
the
material to avoid damaging the cooling pipes at the
rear of the refrigerator.