Battery Installation; Charging Your Battery; Start To Use - Qstarz BT-Q816X Guía De Instalación Rápida

English
................................................................................................................................................................................................................
C. Battery installation
C‐1 Put Battery in place: Press the PUSH button on the bottom side
of the unit (1) and pull out the battery cover. Insert battery in the
unit (2) and put battery cover on to the cabinet (3), then push down
and force it forward to fit firmly (4).
C‐2 Take Battery out: Press the PUSH button on the bottom side of
the unit (1) and pull out the battery cover (2). Then take out the
battery from the unit (3).
D. Charging your battery
For the first time using the BT‐Q816X,
please charge battery until it is fully
charged. Take the power cable and
connect it to the power jack (mini USB
type) and recharge through travel charger
or car cigarette adaptor. This will begin to
charge the battery. Charging time is 3
hour typically.
‐ When the Power LED is Red, battery power is low status. Please
recharge.
‐ When the Power LED is Green, the battery is under charging mode.
‐ When the Power LED is off, the battery is fully charged.
E. Start to use
E‐1 Activate the Bluetooth function in your PDA/Smart phone or
PC
Before activating the Bluetooth function in your PDA/PC, please
switch on BT‐Q816X Receiver for paring and check if your device is
equipped with Bluetooth function. If not, you may need to acquire an
optional CF/SD Bluetooth card or Bluetooth dongle.
.........................................................................................................................................................................................
2 www.Qstarz.com