Operation - Husqvarna DS150 Manual Del Usuario

4. Attach the product with the nut.
To attach the product with a Husqvarna
vacuum plate
WARNING: Do not use the product in
combination with the vacuum plate when
you drill in walls or ceilings.
WARNING: The support surface must be flat
and of good quality. The product can
become loose if the vacuum plate cannot
seal fully against the surface.
WARNING: Use of vacuum plate is only
recommended together with these
Husqvarna drill motors: DM200, DM220,
DM230, DM280 High speed. Use of other
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the operator's manual for the drill motor
carefully and make sure that you understand the
instructions.
• Do the daily maintenance. Refer to
maintenance on page 10 .
To adjust the angle of the drill column
The drill column can be tilted 0–60°.
1341 - 002 - 24.10.2019
1. Loosen the level adjustment screws. They must be
2. Connect the vacuum hose and start the pump.
3. Tighten the level screws until you feel pressure on
To install the product with an all thread rod
•
•
•

Operation

Daily
drill motors can cause the product to
become loose.
above the bottom of the vacuum plate.
WARNING: The minimum pressure must
be -0.85 bar to seal the vacuum plate
tightly to the surface.
the screw.
WARNING: The level adjustment screws
must touch the surface when when you
use the vacuum plate. If not, the vacuum
plate can come loose.
Use an all thread rod to install the product to a wall
or ceiling.
Use an all thread rod when it is not possible to use
an expander bolt.
Use washers and nuts to tighten the all thread rod.
9