RectorSeal AquaGuard 4000 Serie Instrucciones De Instalación

AquaGuard ® 4000 Series Water Sensor & Drain Port - Titan, Goliath, Goliath Furnace/Value Series
Work Safe, READ THIS!
ATTENTION: FAILURE TO READ AND COMPLY WITH ALL WARNINGS, CAUTIONS AND INSTRUCTIONS PRIOR TO STARTING INSTALLATION MAY CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE AND VOID WARRANTY.
STOP/READ: This device must be installed in accordance with manufacturer's instructions. This unit must be in accordance with all applicable local plumbing, drainage and
electrical codes.
WARNING: Remove electrical shock hazard – DISCONNECT THE POWER BEFORE INSTALLATION to avoid electrical shock and/or equipment damage. Do not use on
circuits exceeding 24 volts to avoid damage to switch, shock or fire hazard.
NOTE: In any installation where property damage and/or personal injury might result from an inoperative switch, a back-up system(s) and or alarm should be installed.
NOTE: The AquaGuard Drain pans and float switches must only be installed by a licensed contractor or under the direct supervision of one. Condensation pan must be properly
maintained after installation and be kept free from foreign objects, rust or other obstructions that might interfere with the proper operation of the AquaGuard float switch.
Instructions
NOTE: To ensure proper performance of product, instructions must be followed.
Inspect the drain pan for any shipping damage that may have occurred.
If cracked or broken, DO NOT USE!
1. Remove the threaded nut from the drain housing/ float switch carrier. (fig. 1)
2. Install the drain housing from inside the pan MAKING SURE THE RUBBER GASKETS ARE ON THE INSIDE OF THE PAN. (fig. 2)
3. Screw the nut onto the drain housing from outside the pan and securely hand tighten. (fig. 3)
Threaded
nut
(fig. 2)
4. Install the Float Switch onto the Drain Housing by inserting flat plastic slide into the corresponding receptacle on the housing. (figs. 4,5)
Installation Instructions
Drain
housing
Rubber
gasket
Rubber Gasket
(fig. 1)
Threaded nut
Drain
housing
(fig. 3)
AG-4100
AG-4200
AG-4300
Threaded Nut
Drain Housing
Float Switch