Ryobi A25RT03 Manual Del Operador página 15

ATTACHING THE VACUUM HOSE
See Figure 18.
The vacuum port molded into the fence will accept either a
1-1/4 in. or 2-1/2 in. vacuum attachment.
CLAMPING THE ROUTER TABLE TO A WORK
BENCH
See Figure 19.
 Unplug the router table and/or the router.
 Place the router table right side up on a sturdy work
surface; e.g., leg stand, workbench, counter top.
 Using a clamp, insert the top front of clamp through the
opening in the router table leg.
 Tighten clamp securely.
MOUNTING THE ROUTER TABLE TO A WORK
BENCH
See Figure 20.
 Unplug the router table and/or the router.
 Place the router table right side up on a sturdy work
surface; e.g., leg stand, workbench, counter top.
 Mark the holes with a pencil.
 Remove the router table.
 Drill four holes through the work surface.
 Place the router table back on the work surface, aligning
the holes in the table legs with the holes in the work
surface.
NOTE: Position the router table surface at approximately
hip height.
 Insert four bolts (not included, 1/4-20 recommended) and
tighten securely with flat washers, lock washers, and hex
nuts (not included).
ASSEMBLY
VACUUM
WORK TABLE
FLAT
WASHER
HEX NUT
15 - English
PORT
VACUUM HOSE
CLAMP
LOCK
WASHER
Fig. 18
Fig. 19
BOLTS
WORK TABLE
Fig. 20